ZME Z-Wave Plus Z-Uno Board
Z-Uno is the first and only easy to use developer board that allows you to create your own Z-Wave device without deep knowledge of Z-Wave protocol or programming. Z-Uno is a mix of Z-Wave home automation radio protocol power and Arduino simplicity. Being inspired by Arduino project Z-Uno inherits all concepts of easy-to-use hardware and software solutions, keeping maximum flexibility.
Z-Uno is a fully DIY product. It is made for those who are limited by existing choice of Z-Wave products and wants to extend their smart homes with more sensors and actuators: connect LEDs, buttons, switches, motors or any low voltage sensor including most of Arduino compatible sensors.
You can find many example projects and comprehensive tutorials on the Z-WAVE.ME Z-Uno website.
This product integrates with all Australian certified (921.42MHz) Z-Wave controllers including:
- Vera Edge
- Fibaro Home Center 2/Lite
- Z-Wave.me RaZberry Card
Technical Specifications
|
RF Protocol
|
Z‐Wave Plus (500 series chip)
|
|
RF Frequency
|
921.42Mhz ‐ AU/NZ approved RF for Z‐wave
|
|
Z-Wave Device Type
|
Binary/Multilevel switch,
Binary/Multilevel sensor, meter |
|
Power
|
USB 5V, external 3V, external 7-18V or battery
|
|
Hardware
|
28kB Flash memory for sketches
2 kB RAM 26 GPIO 1 USB (serial port) 64 kB EEPROM |
|
Operation Range
|
Up to 30m indoors (with no obstacles)
|
|
Z-Wave Channel Types
|
Binary/Multilevel switch,
Binary/Multilevel sensor, meter |
|
Operation temperature
|
10 ~ 40 °C
|
|
Storage temperature
|
‐10 ~ 60 °C
|
|
Weight
|
10g
|
|
Board Dimensions
|
39mm x 20mm x 16mm
|
|
Antenna Length
|
86mm
|
|
Housing
|
N/A
|
